Scrub drying, single work step (direct method)

Removing stubborn dirt from floor coverings in a single work step using the scrubber-dryer. Suitable for water-resistant, non-textile floor coverings.

Zum Tutorial
01

Preparatory work

  • Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.

  • Check, equip and ready the machine and all accessories in compliance with the instructions for use.

  • Fill the fresh water tank with cleaning product solution in accordance with the dosing instructions. For machines with an integrated dosing system, fill cold water into the fresh water tank and refill the cleaning product as needed.

  • Put up the warning sign.

  • Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).

  • Wet mop any areas (e.g. corners) that cannot be reached with the machine.

02

Main task

  • Switch on the machine and lower the suction nozzle.

  • Use the machine with suitable pads or brushes to scrub-dry the open area in overlapping passes.

  • Perform a visual check.

03

Final steps

  • Remove the warning sign.

  • Empty the waste water and the fresh water tank, rinse them and leave them open to dry.

  • Rinse the pads, brushes and the suction nozzle with water.

  • Replace the pads, brushes and suction lips as needed.

  • Check the battery level and recharge as needed.

  • Dispose of any waste.

  • Clean the cleaning equipment and replace as needed.

04

Comments

  • Wear the personal protective equipment (PPE) required by company regulations, safety data sheets and / or instructions for use.

  • Always check in advance which product meets your requirements (see Wetrok Cleaning & Care Instructions).

  • Wetrok AG accepts no liability for damage caused by improper use or incorrect product selection.

Download method as PDF

Weitere Methoden

To the method overview

Dust-binding dusting (disposables)

Dust-binding dusting Reusable

Damp wiping with spray

To the method overview