Sweeping / Vacuum sweeping using a machine

Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.

Block off the area or put up warning signs.

Check, equip and ready the machine and all accessories in compliance with the instructions for use.

Pick up and dispose of very coarse, loose dirt (e.g. strings, bottles, etc.) by hand.

Use a broom to sweep out corners and hard to reach areas.

Note: Switch off the fine dust filter unit of the machine on wet surfaces.

Use the machine to first sweep / vacuum sweep along the edges (utilising the side brush on the bottom). Then start sweeping / vacuum sweeping the open area in slightly overlapping passes or according to visible signs of dirt (side brush on the top).

Perform a visual check.

Reopen the area or remove the warning signs.

Check the fine dust filter and shake off the dust or replace the filter as needed.

Empty the dirt collector.

Dispose of any waste.

Clean the cleaning equipment and replace as needed.

Check the battery, fuel and oil level.